Plan Section

General

In ProtaDetails, slab section can be generated via Plan Section.

However, please note that ProtaDetails is reflecting the reinforcement information which transferred from ProtaStructure. Hence, design of slab must be done and the project model must be saved prior to creating Plan Section in ProtaDetails. For more details of slab analysis and design in ProtaStructure, please refer to Slab Analysis and Design Procedure.

Navigation

The section view of slabs can be generated by creating a plan section in form plan. The steps are shown in the recorded GIF file below:

Member Labels in Floor Plan Sections

Floor plan sections in ProtaDetails include member labels. Member labels can be turned on or off using the section properties window.

• Related Articles

• ProtaDetails Basic Training Guide

  Thank you for choosing ProtaDetails – a revolutionary automated detailing, drawing management & structural component design program that enables you to: Create automatic detail and general arrangement drawings from ProtaStructure models Produce ...

• Flat Slab and Raft Design with Slab Patch Panels

  Utilizing base reinforcement in the entire floor and calculating additional support bars at column regions is a powerful method for economical and practical design. This is one of the many things that you can do by taking advantage of the advanced ...

• Draw Full Line Between Section Mark

  General Section lines drawn in Form Plan layout and beam elevations can be shown in full line.  Navigation "Settings" > "Options" > "Other" Below images show the effect of the option

• Flat Slab Modelling, Analysis and Design

  This design guide discusses the modeling, analysis and design of flat slab model in detail at here: Flat Slab Training Manual Users who wish to understand the modeling, analysis and design for flat slab model are recommended to read this document.

• Working with Slab Loads

  Slab Load Properties "Slab Load Properties" will be loaded when the "Point, Line and Area Loads" option in the "Loading " ribbon is selected. A new slab load can be defined by arranging the fields in the properties form and then by clicking the ...