Manual Connection Detailing
Modelling Welds for Pipe Sections
To create the welds, please follow the instructions below: a. Ensure all end of the pipes are within the connecting member section. In case of the pipe is protruded out from the connecting member, we can offset the member end by adjusting the x, y, z ...
Cut Operation
General In manual detailing, cut operation can be used to cut unwanted area/region to ensure the members is correctly connected. The "Cut Operation" toolbar are shown as below : Place the mouse cursor over the icon to expose the Tooltip which will ...
Manual Connection Detailing Overview
Connection that are not covered in Auto Connection Detailing can be easily created using Manual Connection Detailing. Below shall be the list of topic that covered to allow user to understand how to manually create connection using ProtaSteel: Manual ...
Manual Connection Detailing
The existing connection macros will work for the most common connections but they might not work for non-standard situations. For such situations, you can manually create the connection by creating plates, bolts, welds & cuts. Trimming, chamfering & ...